Please follow the below instructions in order to pitch your awning correctly:
-
Assemble the poles and insert into pole sleeves.
-
Locate one end of the poles in Ring & Pin system as Figure 1 below.
- Push poles into an arch from opposite side and locate other pole end on to corresponding Ring & Pin system on flysheet.
-
Tension the webbing strap at the pole end.
-
Position open end of awning towards tent front door.
- Secure in position by zipping awning onto corresponding zip at front of tent and clipping the rear awning clips onto the front tent pole.
- Peg out awning base at contact point with tent and attach rear side awning clips to front tent pole.
-
Peg out front of awning and front guylines.
-
Peg out ALL remaining guylines and peg points as figure 2.
Figure 1
Figure 2
